Without overloading, this is critical. Here are the commands that you need to issue to configure NAT on the router: interface FastEthernet 0/0 description Inside Interface ip address 192.168.8.1 255.255.255.0 ip nat inside exit interface FastEthernet 0/1 description Inside Interface ip address 192.168.9.1 255.255.255.0 ip nat inside exit interface FastEthernet 0/2 description Outside Interface. Fastethernet 0/0 其中 的 来 0/0代表路由器 源 上的 2113 0号 物理 接口 ， 5261 0/0.1代表0号物理接口上的1号虚拟子 4102 接口，例如0/0.2都是 1653 相同 意思，只是子接口号不同。 划分子接口的用意是：多个vlan要通信，它们各自的网段不同，网关也不同，而交换机只连接路由器上的一个物理接口，这个接口不. Without overloading, this is critical. Here are the commands that you need to issue to configure NAT on the router: interface FastEthernet 0/0 description Inside Interface ip address 192.168.8.1 255.255.255.0 ip nat inside exit interface FastEthernet 0/1 description Inside Interface ip address 192.168.9.1 255.255.255.0 ip nat inside exit interface FastEthernet 0/2 description Outside Interface. (Choose two) A) Interface fastethernet 0/0.4 B) Dot1q enable C) Dot1q enable 4 D) Trunking enable E) Trunking enable 4 F) Encapsulation dot1q 4 33 minutes ago The GaVS resource where students can locate information regarding Canvas, student email, registration and O365 is called the: Student Success Site Med. When I do a show int I get the message FastEthernet0/0 is up, line protocol is down. However the serial interface with the DLCI is up. In fact that is how I am able to remotely telnet into the router through the serial interface but cannot even ping the FastEthernet interface.
Most of Cisco's routers which are released on or after 2005 has L2TPv3 over IPsec protocol function. (If not, you might be able to upgrade the IOS version to support it.)
Before setup Cisco router you have to setup the SoftEther VPN Server settings. https://vtcyp.over-blog.com/2020/12/icon-slate-4-4-8.html.
On the above screen, check the 'Enable EtherIP / L2TPv3 over IPsec Server Function' and click the 'Detail Settings' button. The following screen will appear.
In this screen you have to define a mapping-table between L2TPv3 client (router)'s ISAKMP (IKE) Phase 1 ID, and the destination Virtual Hub's name, username and password. https://downifile901.weebly.com/cardhop-1-0-7.html.
Inet network scanner 2 7 0. On the above example, VPN connection attempts from any L2TPv3 routers will be regarded to use the 'l2tpv3' username to connect the 'DEFAULT' Virtual Hub. (The 'l2tpv3' user must be registered on the Virtual Hub.)
Beamer 3 1 1 download free. Essentially you should specify the Cisco's router's ISAKMP (IKE) Phase 1 ID on the ID field. However, you can specify '*' (wildcard) to match for any IDs. This is lack of security but this time is just a tutorial. So a wildcard is used. In the long-term running system you have to specify the Phase 1 ID exactly instead of a wildcard.
0 
Star